1·Cause of high vibrated value of turbo-expander gearbox high-speed shaft was analysed in this paper. solution and attention problems were put forward.
详细分析了引起膨胀机齿轮箱高速轴振值高的原因，提出了解决问题的办法及日常运行中应注意的问题。
2·And the magnetic particle detection manner for the roller shaft crack is put forward.
提出了适宜于滚子轴裂纹的磁粉探伤方式。
3·Use the OLD PLANK from inventory on the shaft and proceed forward into passage.
使用从轴上库存旧板，将通过继续前进。
4·By analyzing the calculation result, the problem existed in the design of flexible shaft was found out and corresponding improvement measure was put forward.
通过对计算结果的分析，找出挠性轴设计中存在的问题，并提出相应改进意见。
5·On the basis of past production , puts forward the designing project of double horizontal shaft vibrating mixer, and concretely explicates the vibrating and mixing parametric design.
参照以往的成果，提出了双卧轴振动搅拌机的设计方案，并详细阐述了振动参数和搅拌参数的设计。
6·Based on the work principle of AC motor, the article analyzes the cause and phenomenon of alternating-current motor and puts forward the method of removing shaft current.
根据交流电动机的工作原理，分析讨论其轴电流产生的原因和表象，提出了防止轴电流产生的方法。
7·The forming of automobile′s half shaft by rotary forging technology has been analyzed and a new technological project put forward.
针对汽车半轴摆辗成形进行了工艺分析，提出了一种新的工艺方案。
8·This problem has been successfully solved by adopting method to cut off the path of shaft current, and preventive measures being further put forward.
采取断开轴电流通路的方法，成功解决了这一问题，并提出了进一步的防范措施。
9·Essential shape of the small turning shaft parts is analysed, the united mathematical model is put forward and applied to describing these parts longitudinal automatic single spindle lathe.
对小型回转体类零件的基本形体进行了分析，提出了与其统一的数学模型，并将其用于描述单轴纵切自动车床加工的小型回转体类零件。
10·Through the status analysis on shaft seal system of 9E combined-cycle steam turbine, the improvement for shaft seal overflow is put forward to save energy and reduce consumption.
通过对9E联合循环汽轮机轴封系统的现状分析，提出对轴封溢流的改造以达到节能降耗的目的。